MIL-F-62564(AT)
3.7 Workmanship. Workmanship shall be of the quality necessary to provide fans free from
defects that would affect their appearance, performance or present safety hazards to operating
and maintenance personnel (see 4.7.2).
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract or purchase
order (see 6.2), the contractor is responsible for the performance of all inspection requirements as
specified herein. Except as otherwise specified in the contract or purchase order, the contractor
may use his own or any other facilities suitable for the performance of the inspection
requirements specified herein, unless disapproved by the Government. The Government
reserves the right to perform or witness any of the inspections set forth in the specification where
such inspections are deemed necessary to assure supplies and services conform to prescribed
requirements.
4.1.1 Responsibility for compliance. All items must meet all requirements of sections 3
and 5. The inspection set forth in this specification shall become a part of the contractor's
overall inspection system or quality program. The absence of any inspection requirements in the
specification shall not relieve the contractor of the responsibility of assuring that all products or
supplies submitted to the Government for acceptance comply with all requirements of the
contract. Sampling in quality conformance does not authorize submission of known defective
material, either indicated or actual, nor does it commit the Government to acceptance of
defective material.
4.1.2 Inspection equipment. Unless otherwise specified in the contract (see 6.2), the
contractor is responsible for the provision and maintenance of all inspection equipment necessary
to assure that supplies and services conform to contract requirements. Inspection equipment
must be capable of repetitive measurements to an accuracy of 10 percent (%) of the measurement
tolerance. Calibration of inspection equipment shall be in accordance with MIL-STD-45662.
4.2 Classification of inspection:
a. First article inspection (see 4.4).
1. Preproduction inspection (see 4.4.1).
2. Initial production inspection (see 4.4.2).
b. Quality conformance inspections (see 4.5).
1. Examination (see 4.5.2).
2. Test (see 4.5.3).
c. Control tests (see 4.6).
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business